Eligibility
Sample Exam Questions
The following sample questions are representative of the type of questions you will encounter on the CIC written exams:
1. If unfamiliar with the crane, the operator must
a. become familiar with the crane before operating.
b. handle only light loads.
c. operate the crane slowly at first.
d. not operate the crane.
2. If an outrigger is not visible to the operator during extension or setting, the operator is required to
a. be very careful while slowly extending and setting the outrigger.
b. not be concerned; everyone should be clear.
c. operate the crane without using outriggers.
d. utilize a signal person to direct extension and setting of the outrigger.
3. Load chart ratings apply only when
a. all of the following.
b. the crane is set up and maintained level within 1%.
c. the hoist line is vertical at all times and the load is freely suspended during the lift.
d. the load is picked up directly under the boom tip.
4. What is the proper procedure when raising long loads from a horizontal position to a vertical position?
a. Lift loads away from the crane.
b. Lift loads toward the crane.
c. Long loads cannot be lifted.
d. There is no correct procedure.
5. Boom trucks normally do not have capacities in which operating area?
a. over the side
b. over the front
c. over the rear
d. Capacity in any operating area is never restricted.
6. If the extension and jib are removed from the crane, what is the deduction?
a. There is no deduction.
b. 640 lbs
c. 1,063 lbs
d. 9,396 lbs
7. What action can cause the lattice boom to topple backwards?
a. Stopping the boom suddenly while booming down
b. Starting a swing suddenly at a low boom angle
c. Swinging from the downhill side to the uphill side
d. No action will cause the boom to topple backwards.
8. Lifting “over the front” of a truck crane is not usually allowed unless a front stabilizer is used.
a. True
b. False
